Description
Introduction
ISG centrifugal pipeline pump IS a single-stage single-suction vertical centrifugal pump, it IS applied in the reconstruction IS conducted on the basis of, into a compact structure of the pump, he didn't like IS centrifugal pump coupling, pump impeller IS directly connected to the motor shaft, motor can also be replaced with explosion-proof motor, can be used to transport oil substances, such as cast iron material can also change the stainless steel material, In order to transport corrosive liquids, if the material is changed into stainless steel, the motor is changed into explosion-proof motor, so you can transport flammable and explosive substances.
Flow:3.6m³/H-800m³/H(3600L/H-800000L/H)
Head:12.5M-150M(1.25bar-15bar)
Power:0.75KW-160KW(1HP-215HP)
Applicable medium:Clean water, sewage, sea water, domestic water
Pump body material:Cast iron, SS304,SS316,SS316L
Flow:3.6m³/H-800m³/H(3600L/H-800000L/H)
Head:12.5M-150M(1.25bar-15bar)
Power:0.75KW-160KW(1HP-215HP)
Applicable medium:Clean water, sewage, sea water, domestic water
Pump body material:Cast iron, SS304,SS316,SS316L
Features
1, the pump is vertical structure, import and export caliber is the same, and located in the same center line, can be installed in the pipeline like a valve, with installation foot, increase the stability of the pump, compact appearance, small footprint, low construction investment.2. The IMPELLER of ISG pipeline pump is directly installed on the extended shaft of the motor, with short axial size, compact structure, reasonable configuration of pump and motor bearings, which can effectively balance the radial and axial loads generated by the pump operation, thus ensuring the smooth operation of the pump and low vibration noise.3, the shaft seal adopts mechanical seal or mechanical seal combination, using imported titanium alloy seal ring, medium high temperature resistant mechanical seal and hard alloy material, wear-resistant seal, can effectively increase the service life of mechanical seal.4, ISG pipeline pump easy installation and maintenance, no need to disassemble the pipeline system, just remove the pump nut can be taken out of all the rotor parts.5, according to the requirements of the use of flow and head needs to use the pump series, parallel operation.6. Vertical and horizontal installation of pump can be adopted according to the requirements of pipeline layout.
Working Conditions
◆ The suction pressure ≤1.0mpa, the maximum working pressure or pump system ≤1.6mpa, namely suction pressure + pump head ≤1.6mpa, hydrostatic test pump pressure ≤2.5mpa, please specify when ordering system working pressure. 1.6mpa working pressure pump system should be greater than in the order presented separately, in order to manufacture the pump flow part and a coupling portion using steel materials.
◆ The ambient temperature <40 ℃, relative humidity <40%.
◆ The transmission medium volume fraction of solid particles per unit volume of not more than 0.1, particle size <0.2mm.
NOTE: If with small particles, please when ordering with the media so that manufacturers use wear-resistant mechanical seal.
Technical Specification：
